Skip to main content

Check os version in Linux

Check os version in Linux

The procedure to find os name and version on Linux:
  1. Open the terminal application (bash shell)
  2. For remote server login using the ssh: ssh user@server-name
  3. Type any one of the following command to find os name and version in Linux:
    cat /etc/os-release
    lsb_release -a
    hostnamectl
  4. Type the following command to find Linux kernel version:
    uname -r

Comments

Post a Comment

Popular posts from this blog

A Basic Understanding Of screen On Centos

Description Screen allows you to run scripts or commands in their own virtual window within the terminal, essentially allowing you to have a terminal multi-tasking environment where you can switch between your windows or another users at will. This howto will give you the basics of screen plus some other useful features that may help you in your daily administration tasks. This howto is intended to get you up and running with basic screen functionality within just a few minutes. Please read the manpage for a far more in-depth description of features and options. Requirements These are requirements for successfully completing this document. Root or appropriate sudo access to the system. Doing the Work Basic description of what will be done and what is expected. Install screen if it’s not already installed. yum install screen Setup screen for multi-user mode. Multi-user mode is helpful for sharing a terminal and showing something in real-time because multi-user mode ...
Post a Comment
Read more

Troubleshooting DRBD #Centos #DRBD

Troubleshooting DRBD  This article presents common DRBD problems and solutions. DRBD (Distributed Replicated Block Device) runs on the master and slave nodes only, and is responsible for mirroring the contents of a partition between master and slave.  Typical problems in DRBD include: A lack of Primary-Secondary connectivity The Secondary operating in standalone mode Both nodes reporting connectivity but neither one in the role of master Both nodes reporting themselves in the role of master Verify the DRBD status The following command is used to verify that DRBD is operating normally on the master and slave nodes. drbd-overview When run on the master node, the output should look like the following: 1:r0/0 Connected Primary/Secondary UpToDate/UpToDate C r----- /mnt/drbd  ... When run on the slave node, the output should look like the following: 1:r0/0 Connected Secondary/Primary UpToDate/UpToDate C r----- The following sections are exampl...
Post a Comment
Read more

Get Docker CE for CentOS #centos #docker

Get Docker CE for CentOS Estimated reading time:  10 minutes To get started with Docker CE on CentOS, make sure you  meet the prerequisites , then  install Docker . Prerequisites Docker EE customers To install Docker Enterprise Edition (Docker EE), go to  Get Docker EE for CentOS   instead of this topic . To learn more about Docker EE, see  Docker Enterprise Edition . OS requirements To install Docker CE, you need a maintained version of CentOS 7. Archived versions aren’t supported or tested. The  centos-extras  repository must be enabled. This repository is enabled by default, but if you have disabled it, you need to  re-enable it . The  overlay2  storage driver is recommended. Uninstall old versions Older versions of Docker were called  docker  or  docker-engine . If these are installed, uninstall them, along with associated dependencies. $ sudo yum remove docker \ docke...
Post a Comment
Read more