Skip to main content

Set time and date #Centos #linux

Login to your system with root user or sudo privilege .

1. Type date to confirm the date
#date
or 
$sudo date

Copy the output as shown in image

2. Then set the date as follows

#date -s  <your desired date and time>
#date -s "Thu Jan 31 20:11:13 +0545 2019"
or 
$sudo date -s "Thu Jan 31 20:11:13 +0545 2019"



Comments

Popular posts from this blog

Understanding the dm-multipath Configuration file /etc/multipath.conf #centos7

Understanding the dm-multipath Configuration file /etc/multipath.conf The main configuration file for DM-Multipath is  /etc/multipath.conf . This file is not created by the initial installation of the RPM package. However, the following file is installed in the  /usr/share/doc/device-mapper-multipath-[version]  directory: multipath.conf  – Basic configuration file with some examples for DM-Multipath. This file is used to create the /etc/multipath.conf file. Sample /etc/multipath.conf file The multipath.conf file contains the following sections, and each section contains one or more attributes or subsections. Section Description defaults Defines the default settings for DM-Multipath. These settings can be overwritten by the devices and multipaths sections. blacklist Defines the devices to be excluded from the multipath topology discovery. Devices that are blacklisted are not grouped into a multipath device. blacklist_exceptions Defines the devices to ...

Troubleshooting DRBD #Centos #DRBD

Troubleshooting DRBD  This article presents common DRBD problems and solutions. DRBD (Distributed Replicated Block Device) runs on the master and slave nodes only, and is responsible for mirroring the contents of a partition between master and slave.  Typical problems in DRBD include: A lack of Primary-Secondary connectivity The Secondary operating in standalone mode Both nodes reporting connectivity but neither one in the role of master Both nodes reporting themselves in the role of master Verify the DRBD status The following command is used to verify that DRBD is operating normally on the master and slave nodes. drbd-overview When run on the master node, the output should look like the following: 1:r0/0 Connected Primary/Secondary UpToDate/UpToDate C r----- /mnt/drbd  ... When run on the slave node, the output should look like the following: 1:r0/0 Connected Secondary/Primary UpToDate/UpToDate C r----- The following sections are exampl...